SKU: 54890431898

Kidde Firex 3x KF20 Optical Smoke & 1x KF30 Heat Alarm Kit Mains Powered with 9V Alkaline Battery Back-Up

Sale price$66.83 Regular price$74.26
Save 10%

Pay in installments of $18.57 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 16 - Aug 21

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Kidde Firex 3x KF20 Optical Smoke & 1x KF30 Heat Alarm Kit Mains Powered with 9V Alkaline Battery Back-UpKidde Firex 3x KF20 Optical Smoke & 1x KF30 Heat Alarm Kit Mains Powered with 9V Alkaline Battery Back Up FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS 3x Mains Powered Optical Smoke Alarm (KF20): Mains Optical Smoke Alarm Features: Mains powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat. Once interlinked, the detection of the relevant danger by an individual

Kidde Firex 3x KF20 Optical Smoke & 1x KF30 Heat Alarm Kit Mains Powered with 9V Alkaline Battery Back-Up

FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS

3x Mains Powered Optical Smoke Alarm (KF20):

Mains Optical Smoke Alarm Features:

Mains-powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Optical alarms are for use in escape or circulation routes and in areas where there is a danger of ignition of furniture and surroundings by cigarettes producing slow, smouldering fires.
This mains-powered unit should be installed by a qualified electrician and can be used throughout the home, except in the kitchen where a Firex Heat Alarm is recommended. These alarms comply with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).

  • Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
  • Alarm memory – identifies source unit within interconnecting network
  • Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
  • Auto reset after activation
  • Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
  • Mains operation – 9V Alkaline back-up battery supplied as standard

Mains Optical Smoke Alarm Specification:

  • Model KF20
  • Power Supply 230V mains-powered with 9V Alkailine battery back-up
  • Temperature Range 0ºC to + 40ºC
  • Humidity Range Up to 93% Relative Humidity (RH) non-condensing
  • Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
  • Alarm Dimensions 127 x 127 x 39mm
  • Bracket Dimensions 133 x 133 x 6mm
  • Alarm Weight 242g
  • Warranty 6 years
  • Approvals BSI certified to BS EN14604:2005
  • CE tested and certified Sensor Optical, circular lateral chamber with insect-resistant width slot entry portals and added bug screen mesh
  • Chamber Size 35mm outside diameter x 16mm depth approximate (external)
  • Detection Band Infrared light wavelength
  • Button Test Simulates the effect of smoke within the sensing chamber, checks electronics and sounder
  • Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
  • Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
  • Power Consumption < 15mA
  • Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
  • Battery Back-up User-replaceable alkaline 9V battery (522/6LR61)
  • Power-on Indicator Continuous green LED
  • Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - 3 pulses - space - 3 pulses), soldered contacts
  • Sound Output 85dB (A) minimum at 3 metres
  • Alarm Frequency 3.2 kHz typical
  • Dust Protection In-built foam gasket in rear of alarm to prevent dust ingress into rear of the alarm
  • Alarm Status Red LED flashes approx once every five minutes = normal operation
  • Red LED flashes once a second = sensing smoke (sounder alarm sounds)
  • Red LED flashes once every ten seconds = in hush condition (auto-reset after 15 minutes)
  • Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
  • Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
  • Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
  • SMK4896 – Surface mounting base for added ease of installation
  • Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
  • 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
  • Bracket has 50mm diameter central access hole for cabling
  • Plastics used NORYL – Cover, main body and mounting bracket
  • Lead-Free Status All Firex alarms are lead-free

1x Mains Powered Heat Alarm (KF30):

Mains Heat Alarm Features:

Mains-powered heat alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Mains-powered heat alarms can be used throughout the home in humid or dusty environments where an optical or ionisation smoke alarm is unsuitable, e.g. kitchens, loft spaces and garages.
The Firex range requires installation by a professionally qualified electrician and complies with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).

  • Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
  • Alarm memory – identifies source unit within interconnecting network
  • Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
  • Auto reset after activation
  • Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
  • Mains operation – 9V Alkaline back-up battery supplied as standard

Mains Heat Alarm Specification:

  • Model KF30
  • Power Supply 230V mains-powered with 9V Alkaline battery back-up
  • Temperature Range 0ºC to + 40ºC
  • Humidity Range Up to 93% Relative Humidity (RH) non-condensing
  • Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
  • Bracket Dimensions 127 x 127 x 39mm
  • Alarm Dimensions 133 x 133 x 6mm
  • Alarm Weight 213g
  • Warranty 6 years
  • Approvals BSI certified to BS5446 Part 2: 2003
  • CE tested and certified
  • Sensor Thermistor (Thermal Resistor) within detection unit
  • Button Test Simulates the effect of heat at the sensor, checks electronics and sounder
  • Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
  • Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
  • Power Consumption < 15mA
  • Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
  • Battery Back-up User replaceable alkaline 9V battery (522/6LR61)
  • Power-on Indicator Continuous green LED
  • Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - three pulses - space - three pulses) with soldered contacts
  • Sound Output 85dB (A) minimum at 3 metres
  • Alarm Frequency 3.2 kHz typical
  • Alarm Status Red LED flashes approx once every five minutes = normal operation
  • Red LED flashes once a second = sensing heat in excess of 58ºC (sounder alarm sounds)
  • Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
  • Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
  • Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
  • SMK4896 – Surface mounting base for added ease of installation
  • Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
  • 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
  • Bracket has 50mm diameter central access hole for cabling
  • Plastics used NORYL – Cover, main body and mounting bracket
  • Lead-Free Status All Firex alarms are lead-free

Please note: Alarms are sold individually.

Data Sheet:

Data Sheet for KF20
Data Sheet for KF30

Instruction Manual:

Instruction Manual for KF20
Instruction Manual for KF30
Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 54890431898

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.6 ★★★★★
Based on 17 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
D
Verified Purchase
Dianne
Fort Morgan, US
★★★★★ 5
Men’s oxfords
Size: 10.5, Color: Black
Good quality and perfect fit
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 22, 2026
F
Verified Purchase
Fletch
Waukegan, US
★★★★★ 5
Overall Great.
Size: 10.5 Wide, Color: Black
Great product. Great value. Great style. Overall great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 3, 2026
M
mkhmmr
Lexington, US
★★★★★ 5
Great office space divider without being suffocating
Color: Black, Size: 4' Wide x 6' Tall (Fluted)
This is a nice option for dividing up your office space. It's lightweight enough to be moved when needed, but large enough to create a sound and sight barrier between desks. The window design at the top also allows light through so that you don't like you are boxed in. Overall, this is a great office divider. It's well made, large enough to make a difference, and portable if you need to move it. And it does this without making you feel like you're in a box thanks to the fluted clear window at the top. It does the job I need it to.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 7, 2023
T
TheRealYoshihito
Grantham, US
★★★★★ 5
Dividing the Office
Color: Black, Size: 4' Wide x 6' Tall (Fluted)
The Hush Screen Portable Office Divider has been a game-changer for my workspace. It not only adds a touch of privacy but also beautifully separates the area, creating distinct zones within my office. The divider's design is functional and modern, seamlessly fitting into my decor. Its portability allows me to reconfigure my workspace as needed, adding an element of versatility. Setting it up was a breeze, and it was sturdy enough to stand on its own. If you're looking for an effective way to enhance your office layout, this divider is a fantastic choice. I can definitely recommend it!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 11, 2023
J
JJH
Draper, US
★★★★★ 4
Light commercial grade quality
Color: Black, Size: 4' Wide x 6' Tall (Fluted), Color: Black, Size: 4' Wide x 6' Tall (Fluted)
This VERSARE hush screen portable divider appears to be well made and of light commercial grade quality. The lightweight aircraft aluminum frame and black fabric panel aren’t as heavy duty as the commercial grade steel panels of years past, but this panel certainly has adequate durability for home or office use. The sleek modern style is aesthetically pleasing, definitely appropriate for commercial applications, it doesn’t look cheap, or out of place. It’s freestanding and portable, with optional locking wheels, measuring 4’ wide X 6’ tall. The top panel is made of a clear fluted fiberglass, providing a window for natural light to filter through. I’m currently using it in my home office to partition of a separate workspace for my college student. It works very well for my purpose, I now have two relatively private workspaces in one office. It’s fairly easy to assemble, but the instructions could be more detailed and illustrative. One thing that I don’t like about it, is that the legs only slide in place, but they don’t bolt to the frame, allowing the legs to slide out of place when the panel is lifted up. The problem isn’t as magnified with the wheels installed, because the panel is then rolled, rather than lifted. It would be much easier to lift and move if the legs were bolted in place. But since I won’t be moving the divider very often, it’s not a deal breaker. Overall, I’m very pleased with the quality and look of this portable divider. At just under $555, it’s perhaps a tad bit overpriced, but still a reasonably good value. I recommend this VERSARE portable divider for home or office applications.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 29, 2023

recommand products