12001656 Oven Temperature Sensor for Whirlpool Kenmore Ovens - 2 Pack

12001656 Oven Temperature Sensor for Whirlpool Kenmore Ovens - 2 Pack12001656 Oven Temperature Sensor Key Features Precision RTD (Resistance Temperature Detector) probe designed to monitor internal oven cavity temperatures. High accuracy thermal response to ensure consistent baking, roasting, and broiling performance. Stainless steel probe housing provides resistance to corrosion and high heat oxidation. Includes two styles of plug and play wiring harnesses to ensure compatibility with varying manufacturer connector

12001656 Oven Temperature Sensor

Key Features

• Precision RTD (Resistance Temperature Detector) probe designed to monitor internal oven cavity temperatures.
• High-accuracy thermal response to ensure consistent baking, roasting, and broiling performance.
• Stainless steel probe housing provides resistance to corrosion and high-heat oxidation.
• Includes two styles of plug-and-play wiring harnesses to ensure compatibility with varying manufacturer connector types.
• Designed to maintain a standard resistance of approximately 1080 ohms at room temperature (75°F).

Replaces / Cross-Reference Part Numbers

• AP4009009
• PS1570174
• 74004943
• 12001554
• 12001357
• 74003390
• 7430P003-60
• 12001656VP
• AH1570174
• W10127323

Compatibility & Fitment

• Whirlpool: WFE, WFG, and RBS series ranges and wall ovens.
• Kenmore / Sears: Models starting with 664, 665, 911, and 564 prefixes.
• Maytag: MER, MGR, and MEW series.
• Jenn-Air, Amana, Admiral, Magic Chef, and Roper: Various electric and gas oven models.

When to Replace

• Inaccurate Temperatures: Oven runs significantly hotter or cooler than the digital display indicates.
• Error Codes: Control panel displays "F3" or "F4" fault codes (common for sensor circuit issues).
• Uneven Cooking: Food is consistently undercooked or burnt despite following standard recipes.
• Sensor Failure: The probe shows "Open" or "Short" circuit results when tested with an ohmmeter.
• Physical Damage: The metal probe is bent, cracked, or showing signs of severe pitting.

Installation Tips

• Disconnect the appliance from the electrical power supply before attempting any service.
• Access the sensor from inside the oven cavity by removing the two mounting screws located at the rear of the oven wall.
• Gently pull the sensor forward until the wiring plastic disconnect is visible; take care not to let the wires slip back through the hole into the insulation.
• If the provided connector does not match, use the included ceramic wire nuts to splice the new sensor onto the existing oven wire harness.
• Ensure the probe does not touch the interior oven walls or the heating elements, as this will result in false temperature readings.