Kjams Rotary 2 - Dual Rotary Speaker Simulator

Kjams Rotary 2 - Dual Rotary Speaker SimulatorA dual speed rotary simulator! This pedal features true bypass, built in speed switch, external speed switch input, external expression pedal input, output level control, real wood control panel, and three program control pots. The pedal is based on the Spin FV 1 DSP chip. It is designed and assembled in Holland, Michigan, USA. The Rotary 2 pedal has two PROGRAMS, selectable by the toggle switch: Single (down) Rotary with two Speed controls and Horn

A dual-speed rotary simulator! This pedal features true bypass, built-in speed switch, external speed switch input, external expression pedal input, output level control, real wood control panel, and three program control pots. The pedal is based on the Spin FV-1 DSP chip. It is designed and assembled in Holland, Michigan, USA.

The Rotary 2 pedal has two PROGRAMS, selectable by the toggle switch:
-Single (down) - Rotary with two Speed controls and Horn/Woofer mix control.
-Dual (up) - Rotary with two Speed controls, Horn/Woofer mix control, and a second Horn (makes it chorus-y)

FOOTSWITCHES
-Bypass is a standard bypass/enable latching switch.
-Spd1/Spd2 toggles the rotary speed between the settings on the two Speed controls. See below.

POTS
-Speed controls
--The two Speed controls set the maximum and minimum speeds.
--Which Speed control is currently active is set by the Spd1/Spd2 switch.
--If Speed 1 control is set lower than Speed 2, pressing the Spd1/Spd2 switch will cause the speed to gradually change from one speed setting to the other.
--If Speed 1 is set higher than Speed 2, pressing the Spd1/Spd2 switch will cause the speed to immediately change from one speed setting to the other.
-Hi/Lo Mix is the mix of the horn and woofer. It acts similar to a tone control.
-Volume controls output level.

JACKS
-In and Out jacks are standard mono, right to left.
-Spd1/Spd2 external input functions in parallel with and exactly like the Spd1/Spd2 footswitch.
-Expression replaces the middle/lower control, Speed 1.
--If the last tap on Spd1/Spd2 has set the pedal to Speed 1 control, the Expression pedal controls the speed.
--If the last tap on Spd1/Spd2 has set the pedal to Speed 2 control, the Expression pedal does not control the Speed until Spd1/Spd2 is pushed again.

POWER
-Input power is standard center-negative 9VDC.
-The pedal draws 62mA.
-The pedal is safe with higher voltages, up to 18VDC, but using higher voltages will not affect the sound, and we discourage using them.