Rear Supra Emblem Overlay (Various Colors) - 2020+ Supra

Rear Supra Emblem Overlay (Various Colors) - 2020+ SupraVinyl overlay for the factory rear SUPRA emblem on the 2020+ Toyota GR Supra (A90) Adds color or texture to the factory black emblem 11 options including 3D Carbon Fiber Comes with 2 stickers backup included Wet install easy alignment with the "U" in SUPRA as your guide Made in the USA by StickerFab Add Color to the Rear SUPRA Emblem The factory rear SUPRA badge on the 2020+ Toyota GR Supra A90 is black which blends into the bodywork and disappears.

• Vinyl overlay for the factory rear SUPRA emblem on the 2020+ Toyota GR Supra (A90)
• Adds color or texture to the factory black emblem — 11 options including 3D Carbon Fiber
• Comes with 2 stickers — backup included
• Wet install — easy alignment with the "U" in SUPRA as your guide
• Made in the USA by StickerFab

Add Color to the Rear SUPRA Emblem

The factory rear SUPRA badge on the 2020+ Toyota GR Supra A90 is black — which blends into the bodywork and disappears. This vinyl overlay drops right on top of it to add color or texture without removing or replacing anything. Choose from solid colors, or go with the 3D Carbon Fiber option for a textured look that adds depth to the emblem. Ships with two stickers — one to install, one backup in case of a stretch or misalignment. Made in the USA by StickerFab.

Installation

Wet install recommended for easy alignment and clean results.

1. Clean the emblem thoroughly — remove all dirt, debris, and wax residue
2. Peel the vinyl and immediately mist the adhesive side with slightly soapy water (1 drop dish soap per cup of water) — this lets you reposition if you're off
3. Use the "U" in SUPRA as your alignment guide — center on that letter first, then lay the rest down
4. Make small adjustments as needed while the adhesive is wet. If you're significantly off, peel up and start again
5. Once aligned, push water out from the center to the edges using firm finger pressure
6. Apply light heat with a hair dryer or heat gun to increase adhesion and dry the water
7. Let the car sit in the sun or give it time to dry fully — the edges may lift slightly until completely dry. Come back with the heat gun for a final pass once dry

Heat note: If the heat is uncomfortable on your skin, it's borderline too much for the vinyl in this application. Low heat, multiple passes.

Fitment

Fits: 2020+ Toyota GR Supra A90 (all trims). Designed for the factory rear SUPRA badge.

FAQ

Does this replace the factory emblem or go on top?
It goes on top of the factory emblem — no removal required. The vinyl overlays the existing badge surface.

Why does it come with two stickers?
The backup piece covers the most common install issue: stretching or misaligning the first piece. The vinyl can stretch slightly when peeling, so having a second one means you're covered.

What does the 3D Carbon Fiber look like?
It has a woven carbon fiber texture that reflects light differently at different angles, giving the emblem a layered, textured depth. It's a dark material — not bright — but adds a premium look that plain black doesn't have.

How long does the adhesive take to fully cure?
The edges may lift slightly until the adhesive is completely dry. Keep the car in the sun or use a hair dryer to fully cure. Come back for a final heat pass once dry and press the edges down firmly.