SKU: 14419244002

Strange Pro Series Rear Brake Kit For 86-93 Mustang With OEM Ends & Strange Parts 1 Pc Rotors, 4 Piston Calipers & DRM-35 Metallic Pads

$371.25 $412.50
Save 10%
No.2 Bestseller on sm10m.ch >

Pay in installments of $103.12 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 24 - Aug 29

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Strange Pro Series Rear Brake Kit For 86-93 Mustang With OEM Ends & Strange Parts 1 Pc Rotors, 4 Piston Calipers & DRM-35 Metallic PadsPart Number: B1714WCM Designed Specifically For Drag Racing For 1986 1993 Mustang 8. 8 With OEM Housing Ends Requires Strange axles and C Clip Eliminator Kit 5 lug bolt pattern 2. 500 brake offset 4 Lug Option Available at an additional cost One Piece Forged Steel Rotors B2792 B2793 Directional slots increase air flow and reduce weight One piece design eliminates bolts & safety wire Hat section drilled & milled to further reduce weight 4 1 2, 4 3 4 &

Part Number: B1714WCM

Designed Specifically For Drag Racing

For 1986-1993 Mustang 8.8 With OEM Housing Ends

Requires
• Strange axles and C-Clip Eliminator Kit
• 5 lug bolt pattern
• 2.500″ brake offset

4 Lug Option
Available at an additional cost

One Piece Forged Steel Rotors – B2792 / B2793
• Directional slots increase air flow and reduce weight
• One piece design eliminates bolts & safety wire
• Hat section drilled & milled to further reduce weight
• 4 1/2″, 4 3/4″ & 5″ Uni-Lug bolt circles for both 1/2″ & 5/8″ studs

Four Piston Directional Calipers – B5002 / B5004
• Aluminum bodies drastically reduce weight
• 1.625″ & 1.750″ pistons vary pressure decreasing pad taper
• Stainless steel pistons resist corrosion
• Anti-rattle clips reduce brake pad vibration and noise

DRM-35 Metallic Brake Pads – B5020
• Provides high resistance to brake fade
• Recommended for vehicles going over 150 MPH in the 1/4 mile
• Maintains decent starting-line cold holding capabilities
• May leave pad residue on rotors when not using parachute
• While common, it’s recommended to remove when installing new pads

Aluminum Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance

Need More Wheel Clearance?
Evolution 4 Low Profile Caliper Option – OPRB10

Want Billet Calipers?
Evolution 4 Billet Caliper Option – OPRB07

Brake Hoses & Lines Are Not Included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 14419244002

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.9 ★★★★★
Based on 29 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
M
Verified Purchase
Mark
San Leandro, US
★★★★★ 2
Decent, but be careful of frequent use.
Size: 12 Pairs / 24 pcs, Size: 12 Pairs / 24 pcs
The looks are very nice, functional if left alone once assembled. After that I would leave them alone otherwise you risk the main male portion just coming loose of the housing, sound quality is decent, nothing to write home about, but again, not very durable. If they could fix that 1 thing, these would be very good buy and value, the rest of each plug is hefty and well made.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 12, 2026
D
Verified Purchase
Dean
Omaha, US
★★★★★ 5
Great Quality and Value - Perfect Connections
Size: 10 Pairs, Pattern Name: Banana Plugs
I used these Monoprice 24k gold-plated banana plugs to connect both my surround sound and desktop speakers, and they work perfectly. The connections are solid and secure, with no looseness or signal issues. They’re easy to install, look great, and offer excellent value for the price. Highly recommended!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 5, 2025
J
Verified Purchase
Janeee
San Leandro, US
★★★★★ 5
Fantastic speaker plug at a great price!
Size: 5 Pack, Pattern Name: Banana Plugs
This is a product that gets the job done effectively, and at a good price. Banana plugs are used to clean up speaker wire - you can generally screw in speaker wire, but banana plugs provide a nice interface that allows you to plug in and remove speaker wire as needed. These closed plugs do a good job terminating / hiding the wire. They fit very well into various components and amps that I own. INSTRUCTIONS to install / use them: * Remove around 1" - 2" of the white casing to expose the red and white individual speaker wires * Strip each wire so ~1/2" metal is showing * Make sure the plug end is screwed in tightly (this does not need to come out) * Unscrew the base of the plug from the other end * WithOUT twisting the metal wiring, insert the wire (match wire color with plug color; start with either one) from the bottom of the plug until the metal sticks out the top * Have ~1/4" metal hanging past the plug * take the wiring and drape it down the sides of the plug (just the smooth side, do NOT cover any of the screw threading or it will be very hard to close it) * Spread the draped wiring around the plug as evenly as possible (makes it easier to screw in later) * Screw the two ends of the plug back together (the side with the draped wiring will go inside the plug) * If you get stuck while screwing it back in, unscrew and adjust the wiring * Repeat for the other side, and you're done!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 10, 2019
L
Verified Purchase
L. Yu
Whiting, US
★★★★★ 4
pretty good banana plugs
Size: 5 Pack, Pattern Name: Banana Plugs
i bought these over 6 months ago and i just installed them to the front left and right floor standing speakers - sony ssf-7000 i have them for over 10 years hooked up to a yamaha 7.1 AVR. alot of people have had trouble installing this - one single banana plug comes in 3 parts - the bottom and top (the banana plug tip) can be unscrewed. what i did was tightened the top first (top being the tip of the banana plug) then unscrew the bottom off completely - make sure you have like 3/4" - 1" (depending on your gauge of wire) of exposed speaker wire that is straight - then thread it through the hole at the bottom up - i then rolled the exposed 3/4 - 1" exposed copper wiring into a ball that is bigger than the hole of the banana plug bottom piece so the wire doesn't fall back through where it came from. then i screwed on the top and middle piece back with the bottom piece - tightening it a bit so i know there's good contact. also make sure the tip is screwed in all the way as well as a double check. what you don't want to do is have the copper wire touch the threaded part of the bottom piece - the wire will cut off from the screwing action. i plugged it into my sony speakers and it wasn't a real snug fit - a bit too loose to feel secure - it didn't seem to go all the way in - but it fit fairly well in my receiver. my intention was to use these banana plugs with my 2 channel set up but i decided to go pre-constructed mediabridge 12 AWG speaker cable instead - those fit my 2 channel set up on my receiver and elacs really snug and secure. i tested it and it works fine. i didn't hear any loss of signal or any extraneous noise. none of my (14 awg?) wiring fell through the bottom and it sounds good. so no complaints there. i bought 5 pairs - but i find that it is an odd number to include a package - even numbered pairs would be better. anyway they seem constructed well - easy enough to install and they do work. thanks for reading
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 12, 2019
A
Verified Purchase
AB
Natrona Heights, US
★★★★★ 5
High quality and robust
Size: 12 Pairs, Pattern Name: Banana Plugs
Easily the best plugs I've found at a reasonable price. Solid feeling with good quality and they look good with easy to see red/black labeling. The tips tend to unscrew too easily, but this is a non-issue when they are in use, just something you have to be careful not to lose when assembling. It's a bit tricky to spread the wire out evenly at the exact right length. If screwing the plug together is hard at all, go back and shorten how much wire you bend over the lip.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 16, 2025

recommand products

Mix Floral Midi Dress with Ruffle Trim
74.99
ConWys Adaptors Extension kit - Permanent Power& Fridge Supply Extension Kit
70.04
ConWys 13 Pin Car Specific Towbar Electrics Wiring For BMW 5 Series 2014-Onwards
175.28
Velvet Sequin Accent Round Neck Puff Sleeve Blouse VT81955
52.99
Scallop Trim Ruffle Sleeve Top
54.99