Pay in installments of $32.50 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Sep 21 - Sep 26
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Detrum GAVIN-8C 8CH 2.4Ghz Transmitter w/ SR6-RC iStone 6-Axis Stabilization & Runway Correction ReceiverDescription Detrum GAVIN 8C 8CH 2. 4Ghz RC Transmitter Detrum GAVIN 8C is a 2. 4GHz 8 channel transmitter applicable to airplanes, helicopters, and multi copter. Based on the GAVIN 6C, GAVIN 8C adds the two channels, and its response time achieves 2. 6ms even with eight channels; it acts synchronously. Also, AA, Ni MH, and Li Po batteries can be used in this transmitter to satisfy more customer needs. The DSSS&FHSS dual spread spectrum technology will
Description
Detrum GAVIN-8C 8CH 2.4Ghz RC Transmitter
Detrum GAVIN-8C is a 2.4GHz 8-channel transmitter applicable to airplanes, helicopters, and multi-copter. Based on the GAVIN-6C, GAVIN-8C adds the two channels, and its response time achieves 2.6ms even with eight channels; it acts synchronously. Also, AA, Ni-MH, and Li-Po batteries can be used in this transmitter to satisfy more customer needs.
The DSSS&FHSS dual spread spectrum technology will enhance the transmitter by increasing the anti-interference performance and transmission distance. It even can be controlled normally in the city center, do not worry about the strong interference from high-voltage lines, signal towers, city WiFi, Etc.
Specifications
| Channel | 8-channel |
| Transmitting frequency | 2.4GHz |
| Power supply | AA batteries 4*1.5V, Ni-MH batteries 4*1.2V, 2S Li-Po |
| Consuming current | less than or equal to 120mA (test mode); less than or equal to 230mA (operating mode). |
| Output power | 10mW (test mode); 100mW (operating mode). |
| Output pulse | 1000ms~2000ms (neutral 1500ms) |
Please click here for Detrum Gavin-8C 8CH Transmitter Manual.
The Detrum SR6-RC is a compact, high-performance 6-channel 2.4GHz 3-IN-1 receiver that integrates advanced iStone 6-axis gyro stabilization and Vector runway correction into a single unit.
Designed specifically for RC aircraft, the SR6-RC enhances flight stability, improves takeoff and landing control, and reduces pilot workload—making it ideal for both beginners and experienced pilots.
Compatible with conventional aircraft, flying wings (delta), and V-tail configurations, this receiver delivers reliable performance across a wide range of RC airplane platforms.
Key Features
All-in-One Flight Control Solution
- Combines Receiver + iStone Gyro Stabilizer + Runway Correction
- Reduces onboard electronics and simplifies installation
- Improves reliability and saves space
Advanced 6-Axis iStone Stabilization
- Built-in MEMS 6-axis gyro with 32-bit ARM processor
- Real-time correction on roll, pitch, and yaw axes
- Enhances flight stability and wind resistance
Vector Runway Correction System - Tricycle Gear Optimized
- Automatically corrects directional deviation during taxi and takeoff
- Improves ground handling and reduces risk of veering
- Dedicated WHEEL output channel for nose wheel steering servo
Four Intelligent Flight Modes
Easily switch between modes via a 3-position switch:
- Gyro Off Mode – Direct control for setup and testing
- Normal Stabilization Mode – Smooth, stable flight with gyro assistance
- Attitude Lock (Aerobatic Mode) – Holds aircraft attitude when sticks are released
- Safe Mode (Self-Leveling) – Automatically levels aircraft for recovery and beginner support
Plug & Play with Smart Calibration
- Automatic gyro zeroing and stick center calibration
- No complex setup required
- Fast initialization on power-up
Wide Airplane Compatibility
- Standard fixed-wing aircraft
- Flying wing (delta)
- V-tail aircraft
Quick Installation & Setup
1. Create a new model on your transmitter
2. Assign a 3-position switch for flight modes
3. Install the SR6-RC near the center of gravity
4. Power on the aircraft on a level surface for auto calibration
5. Adjust servo directions and endpoints in Gyro Off mode
6. Verify gyro correction directions in Normal mode
7. Fine-tune gain and parameters, then proceed to flight testing
Channel Assignment
| Channel | Function | Description |
| AILE | Aileron | Roll control |
| ELEV | Elevator | Pitch control |
| THRO | Throttle | Motor control |
| RUDD | Rudder | Yaw control |
| GEAR | Landing Gear | Also used for runway correction control |
| AUX1 | Auxiliary | Custom function |
| WHEEL | Steering Output | Nose wheel correction servo |
Runway Correction Logic
- Controlled via Channel 5 (GEAR)
- Signal < 1600 μs → Correction ON
- Signal ≥ 1600 μs → Correction OFF
With landing gear:
- Gear down → Correction ON
- Gear up → Correction OFF
Without landing gear:
- Switch ON → Correction ON
- Switch OFF → Correction OFF
Installation Guidelines
- Mount near the center of gravity (CG)
- Ensure arrow faces forward
- Align receiver axes with aircraft roll and pitch axes
- Use included double-sided tape only
- Keep away from motor, ESC, battery, and moving parts
- Position antennas at 90°angles for best signal reception
LED Status Indicators
| LED Status | Meaning |
| Red flashing (fast) | No signal / transmitter off |
| Red flashing (slow) | Ready to bind |
| Solid green | Binding successful / Gyro Off mode |
| Green flashing | Calibration in progress |
| Solid blue | Normal stabilization mode |
| Solid purple | Attitude lock mode - Aerobatic |
| Blue-green | Safe (self-leveling) mode |
| Solid red | Calibration failed |
Specifications
| Parameter | Specification |
| Channels | 6 Channels |
| Gyro | 6-Axis MEMS |
| Sensitivity | -97 dBm |
| Output Signal | PWM (71Hz) |
| Input Voltage | 3.6V – 16V |
| Dimensions | 39 × 20 × 13 mm |
| Weight | 7 g |
Why Choose the Detrum SR6-RC?
The Detrum SR6-RC is engineered for pilots who want greater control, smoother flight, and safer takeoffs and landings without adding complexity. Its integrated stabilization and runway correction make it especially valuable for:
- Scale aircraft pilots
- Beginners learning fixed-wing flight
- Pilots flying in windy conditions
- FPV fixed-wing setups requiring stability and recovery
How to Wire the SR6-RC Correctly:
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy