Oak Crown Foam Latex Prosthetic

Oak Crown Foam Latex ProstheticApply Prosthetics Like The Pros For the best possible results with your Oak Crown Foam Latex Prosthetic, apply skin safe adhesive to the piece up to the edges but NOT on the edge itself, and let the piece dry completely. Using a cotton swab or makeup sponge, apply adhesive to the skin, making sure the adhesive covers a larger surface area than the prosthetic will. Let dry. Press and secure the CENTER of the prosthetic down first, laying the sides flat

Apply Prosthetics Like The Pros

For the best possible results with your Oak Crown Foam Latex Prosthetic, apply skin safe adhesive to the piece up to the edges but NOT on the edge itself, and let the piece dry completely. Using a cotton swab or makeup sponge, apply adhesive to the skin, making sure the adhesive covers a larger surface area than the prosthetic will. Let dry.

Press and secure the CENTER of the prosthetic down first, laying the sides flat slowly and carefully as you go. Press edges firmly into the adhesive. If you like, you can dip a cotton swab in witch hazel and slowly roll the tip against the edges of the prosthetic. This will further blend it into the skin and dissolve the edges until it’s completely seamless.

Using a sponge, stipple more adhesive or liquid latex over the edges of the prosthetic. Let dry completely, then mist the entire area with sealing spray and paint with the makeup of your choice.