Blackmagic Design Spares - ATEM 1M/E Panel - Keycap Label Set

The Blackmagic Design Spares - ATEM 1 M/E Panel - Keycap Label Set consists of the clear plastic lenses and the pre-printed or blank film inserts used to identify the buttons on the 1 M/E Broadcast or Advanced Panels.

Because the 1 M/E panel is a compact professional surface, these labels are essential for distinguishing between your 10 primary inputs, internal media players, and transition types in a high-pressure environment.

What’s Included in the Set

• Clear Snap-on Lenses: The transparent caps that protect the labels and provide the tactile surface for your fingers.

• Pre-Printed Text Inserts: High-contrast film strips featuring common labels such as:

  • Sources: CAM 1–10, VTR, PC, GFX 1–2.

  • Transitions: MIX, WIPE, DIP, DVE, STING.

  • System: SHIFT, CUT, AUTO, FTB.

• Blank Inserts: Frosted or clear strips for custom labeling (useful for specific show titles or unique inputs like "Drone" or "Zoom").

When to Replace Keycaps and Labels

• Clouding or Yellowing: Over years of operation, the plastic lenses can discolor due to the heat of the internal LEDs or exposure to sunlight, making the tally lights look "muddy."

• Cracked Mounting Clips: If a button cap feels "loose" or pops off during a fast transition, the tiny plastic legs inside the cap have likely snapped.

• Surface Wear: Heavy use can cause the smooth plastic to become scuffed or "pitted," which diffuses the light unevenly and makes the text harder to read.

• Studio Reconfiguration: If you are moving from a 4-camera setup to a 10-camera setup, a fresh label set ensures the panel reflects the new hardware reality.

Installation Guide

Repair Level: 1 (Simple).

1. Removal: Use a plastic Keycap Puller or a very thin spudger. Hook under the edge of the clear lens and pull straight up. Avoid prying from the side, as you may scratch the aluminum faceplate or bend the internal button plunger.

2. Inserting Labels: Slide the film strip into the grooves on the underside of the clear lens. Make sure the text is centered; otherwise, the internal LED might cast a shadow across the words.

3. Seating: Align the cap with the square plunger on the panel and press firmly until you hear/feel a click.

4. Testing: Press the button several times to ensure it doesn't "catch" on the edges of the faceplate.

Pro-Tip: Custom DIY Labels

If the standard set doesn't have the specific labels you need (e.g., "HyperDeck 1" or "Social Feed"):

• Printing: Use Matte Transparency Film (available for laser or inkjet). Standard paper blocks too much light, making the button look dim even when it's "On Air."

• Sizing: The labels for the 1 M/E rows are typically 12mm or 15mm square (depending on the panel generation). It is best to print a test sheet on regular paper first to check the fit before using expensive transparency film.

Diagnostic: Label vs. LED Issue

• If the button is dark: Swapping the label won't help. The Internal Button PCB or the LED itself has failed.

• If the button is "sticky": The issue is usually a build-up of dust or soda residue between the keycap and the faceplate. Remove the cap and clean the edges with 99% Isopropyl Alcohol.

Are you looking for the pre-printed "CAM 1-10" labels, or do you need the full set of clear plastic caps to replace broken ones?