KYO-EI KICS COMPRESSION BOLT [CB-28] 20PCS M12xP1.25 CB283S

KYO-EI

CB283S

Size: M12 × P1.25
_x000D_ Overall length: 28mm
_x000D_ Color: Silver
_x000D_ 20 pcs
_x000D_ compression bolt full-length: 28mm
_x000D_ compression bolt attached surplus screws 8mm nut or more is required.
_x000D_ JAN code: 4965581 279831

■ through nut (Long type) dedicated "compression bolt"
_x000D_ product, a product that has a built-in steel ball and spring in an aluminum bolt, goods to be attached to the excess threaded portion of the through-nut which was actually installed (See the figure below. )is. Like "appearance, such as wearing the ultra-long hub bolt !!" You can produce.
_x000D_ Moreover, will improve the self-locking effect of the nut is installed in the tension of the spring.
_x000D_ ● Accessories: 6HEX L-wrench
_x000D_ ※ This product "compression bolt" is, through nut (Long type) will be dedicated.
_x000D_ ※ mounting, should be mounted in the always state the nut is attached to the vehicle (retrofit).
_x000D_ ● mounting, the included 6HEX, please use the L-shaped wrench.
_x000D_ ※ tightening torque of this product "compression bolt" is, it will be up to a maximum of 4N · m (0.4kgf · m).
_x000D_ and hang it more torque, bolt tip is broken, there is a possibility that the elasticity of the spring is eliminated.
_x000D_ ※ thread of the nut takes bill "the figure" is, it depends on the hub bolts protruding amount of each car manufacturer models.
_x000D_ It also has changed the case of the spacer mounted and long hub bolt.
_x000D_ when mounted, and the entire length of the nut, make sure the screws takes allowance Calculate the amount of projection of the "Comp bolt".
_x000D_ ※ This product "compression bolt" is "more than 8mm" surplus thread length is required, "the figure above".
_x000D_ ※ After installation, if you have projections from the vehicle fender, please do not use absolute.
_x000D_ ※ This product, there is a washer effect in the elasticity of the coil spring, but can not completely prevent the loosening of the screw.
_x000D_ wheel nut body and the regular retightening of this product is required.
_x000D_ ※ removal of the wheel, please work from to remove the "Comp bolt" ahead and remove the nut.

Images are for illustration purpose only. Actual product may vary.