UPDATED VERSION Ortur Version 2 Lightburn camera mount

UPDATED VERSION Ortur Version 2 Lightburn camera mountUPDATED VERSION (Works with the New Ortur Master 2 Pro!! and the ATOMSTACK A5) Want a Lightburn Camera mount for your Ortur Version 2? Here it is!!!! Get your Lightburn 160, 150, or 140 degree camera and attach this mount to align your laser job. If Lightburn is sold out of the above degrees and all you could get is the 120 degree have no fear I made an extension just for you. Comes with 2 part main bracket 3 piece camera mount 2 M5 30mm bolts 2 M5

UPDATED VERSION (Works with the New Ortur Master 2 Pro!! and the ATOMSTACK A5)
Want a Lightburn Camera mount for your Ortur Version 2? Here it is!!!! Get your Lightburn 160, 150, or 140 degree camera and attach this mount to align your laser job. If Lightburn is sold out of the above degrees and all you could get is the 120 degree have no fear I made an extension just for you.
Comes with

2 part main bracket
3 piece camera mount
2 M5 30mm bolts
2 M5 Tnuts

DOES NOT COME WITH A CAMERA

Remember to put the usb cable through the rear hole and the fixed camera mount holder before you hook up your camera.

Note
When putting the bracket together I made it super tight for stability. Therefore when putting the dovetail joints together use a hammer to tap it in. Please do not use excessive force it will go in!

The main bracket slides into the back aluminum extrusion. Again it is a tight fit so gently tap with a hammer

Finally if you are having trouble with the camera mount fitting in try to sand it a little. I have already test fit everything but some want there camera mount more loose then I prefer.

Disclaimer: Etsy's Global shipping is slow please know that I have seen items take a month to get to destination.