VW 8v/16v ABA ABF MLS High Compression Head Gasket - 0.5mm + VW 8V 276 N/A application hydraulic tappets performance camshaft

VW 8v/16v ABA ABF MLS High Compression Head Gasket - 0.5mm + VW 8V 276 N/A application hydraulic tappets performance camshaftVW 8v 16v ABA ABF MLS High Compression Head Gasket 0. 5mm Special cylinder head gasket for turbo conversion With this special Turbo multilayer metal cylinder head gasket The compression raise is already integrated in the seal. (Ground and coated) Will accept pistons up to 84. 00mm overbored sized, can be used with smaller bores with no problem too. Compression ratio NEW will depend on the engine used Manufacturer: SPA TURBO Engine Code: All 2 liters

VW 8v/16v ABA ABF MLS High Compression Head Gasket - 0.5mm

• Special cylinder head gasket for turbo conversion
  
• With this special Turbo multilayer metal cylinder head gasket
• The compression raise is already integrated in the seal.
• (Ground and coated)
• Will accept pistons up to 84.00mm overbored sized, can be used with smaller bores with no problem too.
• Compression ratio NEW will depend on the engine used
• Manufacturer: SPA TURBO
• Engine Code: All 2 liters   Blocks of VW 8V and 16V (some small modifications may be necessary in some cases)
• 9A, 6A, ACE, 2E, ADY, ACX ABF, AGG, AKR, ABA, ABBOT, ADW, AAD, AAE, CAST OFF, 3A, SD.

• Similar to OE numbers/Comparable numbers of manufacturers

• Available in 0.9mm; 1.5mm; 2.0mm, 2.5mm and 3.4mm thickness
• We're the  VW Turbo experts!

 

VW 8V 276 N/A application hydraulic tappets performance camshaft

• Application: EA 827 engines Capacities 1781-1847-1984cc from 1986
• 8V Engines with hydraulic tappets
• VW Golf, Corrado, Audi 80, 100, 5000, Quattro, Jetta, Passat, Scirocco, Sharon, Vento, Gol, Pointer, Saveiro.

Duration intake: 276 degrees
Duration exhaust: 276 degrees
Intake valve lift: 11.50mm
Exhaust valve lift: 11.50mm
lobe centers: 110 degrees
valve timing
Intake open: 27 degrees
Intake closes: 69 degrees
Exhaust open: 67 degrees
Exhaust close: 29 degrees
Valve clearance: hydraulic lifters*
Base circle: 34mm
Made of 1045 quenched steel
Billet machined
52-58 HRC

IMPORTANT: this is a performance camshaft, not a OEM replacement, installation may require ECU work, cylinder head work, special lifters and springs, no instructions included, no other parts included.

 

Attention: this camshaft can be used with solid lifters as long as valve lash caps (EMPI 4006, or similar) are assembled and adjusted individually. We strongly recommend that this should be done by a proper professional in order to achieve the correct valve lash values.

All SPA Performance’s camshafts includes CMD anti scoring lube #3

Designed for extreme pressure applications, it’s perfect for camshafts break in procedures, as it withstands pressure values of 40,000 to 50,000 psi, thus avoiding scoring on the high pressure cams - followers interface.